Wells WFAE-30F Operations Instructions download pdf (Page 9)

TROUBLE SHOOTING - OPERATING PROBLEMS

PROBLEM POSSIBLE CAUSE SOLUTION

POWER LIGHT not lit POWER SWITCH not Press POWER SWITCH

(Fryer not operating) in FRYER position to FRYER position

Circuit breaker OFF or tripped Reset circuit breaker

Service wiring problem Correct service wiring

(Fryer operating norm.) POWER LIGHT defective Replace LIGHT

HEAT LIGHT not lit TEMPERATURE CONTROL Set THERMOSTAT to

(POWER LIGHT lit) THERMOSTAT set too low 350ºF

(Cooking oil cold) TEMPERATURE CONTROL Replace THERMOSTAT

THERMOSTAT defective

POWER LIGHT not lit HI-LIMIT THERMOSTAT Allow oil to cool

(Cooking oil cold) TRIPPED Reset HI-LIMIT

(Cooking oil hot) HEAT LIGHT defective Replace LIGHT

COOK LIGHT not lit TIMER not energized Set and energize TIMER only

(CRADLE LIFT raised) when ready to cook

(CRADLE LIFT lowered) COOK LIGHT defective Replace LIGHT

BUZZER LIGHT not lit BUZZER SWITCH in OFF pos. Turn SWITCH ON

BUZZER LIGHT defective Replace LIGHT

BUZZER does not BUZZER SWITCH in OFF pos. Turn SWITCH ON

sound BUZZER defective Replace BUZZER

BUZZER SWITCH defective Replace SWITCH

CRADLE LIFT won’t TIMER not energized Set and energize TIMER only

lower when ready to cook

TIMER defective Replace TIMER

LIFT MOTOR defective Replace LIFT MOTOR

MICROSWITCH misadjusted Adjust MICROSWITCH

CRADLE LIFT won’t TIMER has time remaining Allow TIMER to drop to 0

raise LIFT CRADLE not properly Install white plastic pivot over

assembled to LIFT ROD end of lift rod (see page 3)

TIMER defective Replace TIMER

LIFT MOTOR defective Replace LIFT MOTOR

MICROSWITCH misadjusted Adjust MICROSWITCH

ACTUATOR or LIFT CRADLE Repair / replace damaged

damaged components

FRYPOT COVER COVER leaned back too far Rest COVER on LIFT CRADLE

won’t lower HINGE(S) damaged / dirty Repair / clean / align hinges

or misaligned

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 25 26

No comments

Wells WFAE-30F Operations Instructions Page 9