Wells RWN-2 User Manual download pdf (Page 6)

NOTE: DO NOT discard

the carton or other packing

materials until you have

inspected the appliance for

hidden damage and tested it

for proper operation.

Refer to SHIPPING DAMAGE

CLAIM PROCEDURE on the

inside front cover of this

manual.

WARNING:

PERSONAL

INJURY RISK

Installation procedures must

be performed by a qualified

technician with full knowledge

of all applicable electrical and

plumbing codes. Failure can

result in personal injury and

property damage.

WARNING:

ELECTRIC

SHOCK HAZARD

All servicing requiring

access to non-insulated electri-

cal components must be per-

formed by a factory authorized

technician.

DO NOT open any access

panel which requires the use

of tools. Failure to

follow this warning can

result in severe electrical

shock.

UNPACKING & INSPECTION

Carefully remove the appliance from the carton. Remove all

protective plastic film, packing materials and accessories from the

Appliance before connecting electrical power or otherwise performing

any installation procedure.

Carefully read all instructions in this manual and the Installation

Instruction Sheet packed with the appliance before starting any

installation.

Read and understand all labels and diagrams attached to the

appliance.

Carefully account for all components and accessories before

discarding packing materials. Store all accessories in a convenient

place for later use.

COMPONENTS

1 - 4 ea. DRAWERS (qty. depends on model)

1 - 4 ea. HUMITROL RACKS (if ordered with unit)

FABRICATION

Refer to INSTALLATION INSTRUCTIONS for cutout dimensions and

support fabrication information.

1. Layout front panel cutout dimensions. Cut hole in counter front

panel.

2. Position supplied mounting flange in hole to determine hole

location. Drill hole using #34 drill.

3. Attach flange to front panel using the provided #6 screws.

4. Fabricate rails and rear support as shown in instructions.

INSTALLATION

Refer to electrical specifications on page 1. Circuit must meet or

exceed the amperage and wattage requirements listed.

1. For ease of installation, remove drawer from unit.

2. Slide unit through front panel opening until rear of unit rests on the

rear support.

3. Remove TEMPERATURE CONTROL KNOB and CONTROL

PANEL.

4. Install provided #8-32 speednuts on mounting flange. Secure

mounting flange to the front panel and secure unit to mounting

flange using the provided #8-32 flathead screws.

5. Connect power leads (including ground lead). Wiring or conduit

must be secured to the warmer with a suitable strain relief

(provided by electrical installer).

6. Reinstall CONTROL PANEL and TEMPERATURE CONTROL

KNOB.

INSTALLATION

042 p/n 303334 OpM BI Drawer Warmer

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Wells RWN-2 User Manual Page 6

Comments to this Manuals

Related products and manuals for Water Heaters Wells RWN-2