Wells SS-4 Specifications download pdf (Page 7)

INSTALLATION

4. For “top-mounted” warmers (i.e. warmers mounted from above

the counter top):

a. Verify that provided sealants are applied to the underside

of the warmer top ange prior to setting the unit into the

cutout.

b. After installation, verify that the tabs on the Wellsloks are

turned out to lock the warmer into the counter

c. Apply a thin bead of food-grade silicone sealant around the

ange to seal it to the counter.

d. Wellslok extension kits are available for installing warmers

in counter tops where the standard Wellslok would not

normally reach. The extension kit will adapt to counter tops

up to 1¾” thick.

ELECTRICAL INSTALLATION

1. Refer to the product nameplate. Verify the electrical service

power. Voltage and phase must match the nameplate

specications. Wiring the warmer to the wrong voltage can

severely damage the unit or cause noticeably decreased

performance.

2. Available electrical service amperage must meet or exceed the

specications listed on the specication sheet provided with the

warmer.

3. Warmer and control unit must be connected to an appropriate

building ground. Ground connection will be marked “GND” or

” “ .

NOTE: Wire gauge, insulation type and temperature rating , as

well as type, size and construction of conduit, must meet or exceed

applicable specications of local codes and of the National

Electrical Code.

PLUMBING INSTALLATION

For use in the State of Massachusetts, this appliance must be

installed in compliance with Massachusetts Fuel Gas and

Plumbing Code CMR 248.

1. IMPORTANT: All plumbing installations must be performed by

a qualied plumber.

2. For SS4D, SS-8D and SS10D drainline units, some

jurisdictions may require an approved air gap or other

back-ow prevention device in the drain. It is the responsibility

of the plumber to determine such requirement, to provide and

properly install the required device.

3. For SS4D, SS8D and SS10D drainline units, the drain must be

attached with a union at the drain line tting. This is necessary

to provide for future maintenance of the heating element.

NOTE: Damage caused by

leaks due to improper

installation is NOT covered by

warranty.

CAUTION:

SHOCk HAzARD

The ground lug of this

appliance must be connected

to a suitable building ground.

IMPORTANT:

Contact a licensed electrician

to install and connect electrical

power to the appliance.

IMPORTANT:

Damage due to being

connected to the wrong

voltage or phase is NOT

covered by warranty.

IMPORTANT: Electrical

installation other than as

specied on the specication

sheet will void the UL listing,

and may void the warranty.

NOTE: Plumb connections

must be made in compliance

with all Federal, State and

Local Plumbing Codes and

Ordinances.

2M-308034; Drop-In Round Warmer w/Innite Switch Control

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comments to this Manuals

No comments

Wells SS-4 Specifications Page 7

Comments to this Manuals

Related products and manuals for Food warmers Wells SS-4