Wells SS-4 Specifications download pdf (Page 10)

DAILY CLEANING INSTRUCTIONS

PREPARATIONS: Turn control knob(s) to OFF. Allow warmer to cool

before proceeding.

Remove any insets, pans and/or adapter tops ( if

used). Drain or remove water from well if used for

wet operation.

FREQUENCY: Minimum - daily.

TOOLS: Mild Detergent

Solution: 10 Parts Warm Water to 4 Parts Vinegar

Plastic Scouring Pad

Clean Cloth or Sponge

Food-Grade Silicone Sealant

1. Wipe entire unit down using a clean cloth or sponge and mild

detergent.

2. Use a plastic scouring pad to remove any hardened food particles

or mineral deposits. IMPORTANT: DO NOT use steel wool for

cleaning.

3. Rinse warmer thoroughly with a vinegar and water solution to

neutralize all detergent/cleanser residue.

4. Inspect warmer ange-to-counter seal. Reseal with food-grade

silicone sealant if necessary. Failure to do so may allow grease and

water to leak into insulation and heating element, causing a potential

re and/or electric shock hazard.

5. Inspect warmer tank for damage. Damage to the outer body may

allow grease and water to leak into insulation and heating element,

causing a potential re and/or electric shock hazard. Contact your

Authorized Wells Service Agency to inspect warmer if water or grease

contamination is suspected.

6. Close drain valve. Add proper amount of warm water. Turn control

knob(s) ON and check for proper operation.

CLEANING INSTRUCTIONS

CAUTION:

SHOCk HAzARD

Do NOT splash or pour water

into or over any control panel

or wiring.

CAUTION:

SHOCk HAzARD

Disconnect warmer from

electric power before cleaning

CAUTION:

BURN HAzARD

Allow warmer to cool

completely before cleaning.

2M-308034; Drop-In Round Warmer w/Innite Switch Control

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Wells SS-4 Specifications Page 10

Comments to this Manuals

Related products and manuals for Food warmers Wells SS-4