56
We are sure that your Furlex will give you
many years of enjoyment and wish you
and your crew happy sailing.
19 Checklist
Go through the checklist below and make sure that all the important instructions have been carried
out. This will ensure that the Furlex system functions safely and reliably under all conditions.
19.1 Points to check before sailing
See
chapter
595-240-E Printed in Sweden
www.seldenmast.com
Sweden:
Seldén Mast AB, Tel +46 (0)31 69 69 00, e-mail [email protected] UK: Seldén Mast Ltd., Tel +44 (0)1329 50 40 00, Check that the angle between the halyard and forestay is 5–10° when the
sail is hoisted.
Check that the clearance between the halyard swivel and the top guard is
not less than 50 mm.
Do all the sails used have the maximum luff length or an extension pen-
dant?
Check that no halyard can get caught in the halyard swivel or wrapped
around the luff extrusion.
Check that the line guide eye does not deect the furling line too much,
as this can cause extra friction and wear.
Check that the free turn is functioning, i.e. the tack swivel is turned in the
right direction. A certain load on the sheet should cause the luff section to
rotate one revolution before the tack rotates.
Check that the tack ring does not touch the through-deck tting and cause
extra friction.
Check that the line guide tting does not contact the line drum and anges.
Check that the Furlex stay articulates freely at the upper and lower attach-
ment.
Check that all the split pins are secured.
5
7.1
7.1
5.3
6.3
12.1
4.2
4.3
3.1
3.3
Comments to this Manuals