Wells MOD-400TD User Manual download pdf (Page 12)

3.4 Fitting below deck

The dimension F is nominal. In this area the thickness of the deck should not exceed 20 mm (25/32")

If the deck is thicker than 20 mm, it should be possible to reduce this with a cavity. This will allow

the clearance for the top forward drum edge. If the deck is of sandwich construction, ensure that water

cannot enter the core material and cause structural damage.

Furlex TD incorporates an integral screw for ne adjustment of the under deck dimension "A", This

simplies adjustment between different boats. Extra extension links and toggles are available. (For

dimensions see table 3.2.2).

For larger gaps: use a custom-made stainless steel bar or rod stay. Short wire pendants are not recom-

mended as the forestay load may not be distributed evenly and wire will not resist the torque which

may be produced.

Regarding "Routing of the furling line", see chapter 6.3 for further instructions.

3.4.2 Dimensions for installation

400 TD

440-630

(17 1/3" ~

24 13/16)

210

(8 17/64")

255

(10")

(7/8")

(3/4")

(1")

193

(7 19/64")

3.4.1 Lower bearing assembly

Make sure that there is enough space bet-

ween the forestay tting and deck for the

lower bearing assembly before the hole is

made. (See g 3.4.a and table 3.4.2 for di-

mensions of the lower bearing assembly.)

Fig. 3.4.a

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 55 56

No comments

Wells MOD-400TD User Manual Page 12