Wells WB-2 Operations Instructions download pdf (Page 7)

SERVICING INSTRUCTIONS

CAUTION:

ELECTRIC SHOCK

HAZARD

Unplug appliance from

electric power before

removing any panel or

access cover.

3032730327

SOLID CONDUIT

P/N 55547

CONDUIT, CAST

P/N 50329

Insert small diameter end

into hinge

HINGE PLUG

P/N 50328

HINGE

P/N 50322

SCREW 8-32

P/N 51715 (pk 100)

Pull ground wire up to center

Ground wire gets 4“ of

FIBERGLASS SLEEVE

P/N 54573 (rl 100ft)

after it is pulled into casting

Pull power wires up

above casting numbers

Power wires get 9“ of

RUBBERIZED SLEEVE

P/N 50284 (rl 10 ft)

Ground wire

CASTING AND HINGE ASSEMBLY

CASTING, TOP

P/N 50327

GRID, TOP P/N 50454

GASKET, GRID P/N 50337

Check to insure gasket is

installed flush around casting

CLAMP PLATE, TOP

P/N 50431

INSULATION PAD,

WB ELEMENT TOP

P/N 50430

ELEMENT,

120V 450W P/N 50450

Check for correct voltage

and wattage.

Assemble so that terminals

will be on side of hinge with

solid conduit.

SCREW, 8-32 x 5/16“ P/N 51715 (pk 100)

Do not tighten until all screws are in place.

Ensure that element terminals are centered

in opening before tightening.

Trap ground wire under this screw.

Insert stud on clamping plate of Grid & Element Assembly

into hole in top casting of Casting & Hinge Assembly.

Ensure that gasket is evenly seated, then secure assemblies

with TenzNut (RING, RETAINING P/N 50222 pk 10).

Insert PLUG, TOP CASTING P/N 58628

NOTE: Washer

GRID & ELEMENT ASSEMBLY

A. TOP GRID ASSEMBLY

212 5029732 SvcManual for WB-1, -2 Waffle Bakers

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Wells WB-2 Operations Instructions Page 7

Comments to this Manuals

Related products and manuals for Cookers Wells WB-2