Wells M4200EU Operations Instructions

IMPORTANT: DO NOT DISCARD THIS MANUAL This manual is considered to be part of the appliance and is to be given to the OWNER or MANAGER of the restaur

OPERATION SET TEMPERATURE 1. Make sure the power cord is plugged into the appropriate power supply receptacle. 2. Place the ON/OFF/FAN

OPERATION (continued) DAILY SET-UP PROCEDURES 1. Recommended shelf positions for quality baked products: NO. OF PANS

CLEANING INSTRUCTIONS 10 PREPARATION Allow oven to cool to 65ºC or less FREQUENCY Daily TOOLS Fiber Brush,

CLEANING INSTRUCTIONS (continued) 11 PREPARATION Allow oven to cool to 65ºC or less FREQUENCY Weekly TOOLS Fiber Brush, Plastic Sco

PREVENTATIVE MAINTENANCE 12 CAUTION: Burn Hazard Allow appliance to cool completely before adjusting. Hinge Adjustment HINGE ADJUSTMENT PRECAUT

TROUBLESHOOTING SUGGESTIONS 13 SYMPTOM No power to appliance Oven will not heat Blower fan will not run Door pops open during c

EXPLODED VIEW and PARTS LIST 14

item description svc p/n qty 1 ASSY, CAVITY

EXPLODED VIEW and PARTS LIST (continued) 16

EXPLODED VIEW and PARTS LIST (continued) 17 ITEM DESCRIPTION SVC P/N QTY

GLOBAL WARRANTY STATEMENT NOTE: For your protection, please note that equipment in this shipment was carefully inspected and packaged by skilled pers

WIRING DIAGRAM 18

DESCRIPTION PART NO. CASTER SET, OVEN (set of 4) 21330 OVEN STACKING KIT

PREPARED FOR BY

WARRANTY xi SPECIFICATIONS

FEATURES & OPERATING CONTROLS 2

ITEM DESCRIPTION FUNCTION A. OPTIONAL PREP TOP Allows top of oven to be used as a work

This appliance is intended for use in commercial establishments only. This appliance is intended to prepare food for human consumption. No other use

INSTALLATION NOTE: DO NOT discard the carton or other packing materials until you have inspected the appliance for hidden damage and tested it for pr

EQUIPMENT SET-UP 1. CURB or COUNTER MOUNTING a. Setup the appliance only on a firm, level, non-combustible surface. Ve

7 Refer to the nameplate on the front of the appliance. • Verify the ELECTRICAL SERVICE POWER. • Voltage and phase must match the nameplate specifica