
OVEN
25
REPLACE SPRING FOR FRYHEAD SUPPORT ROD CONVECTION OVEN SECTION - TROUBLESHOOTING SUGGESTIONS
F1 Relay closed or relay ohms low when not cooking
F2 Actual temperature greater than T-SET MAX +60ºF (±35ºF)
F3 Open temperature sensor
F4 Shorted temperature sensor
F5 Relay open or relay ohms high when cooking
F6 No 60 Hz (Cycles per second other than 60 Hz detected)
ERROR CODES
SYMPTOM POSSIBLE CAUSE SUGGESTED REMEDY
Circuit breaker off or tripped Reset circuit breaker
Power cord unplugged or
damaged
Check power cord
Plug in or repair as required
Hood section not "ON"
Verify that Hood Power Switch is
"ON". If "SERVICE REQUIRED"
indicator is lit, rectify filter
problem.
Fuse blown or fuse cap loose
Check power fuses. If blown,
correct problem and replace
fuses
Oven will not heat
Power switch in OFF or FAN
position
Press power switch to ON
Fan switch in OFF position Press fan switch to HIGH or LOW
Oven door not closed
Be sure door is closed and
latched
Temperature control not set Set to desired temperature
Hi-limit control tripped on
excessive oven temperature
Allow oven to cool
Hi-limit will reset
Controller detects error Refer to error codes below
Damaged power switch or wiring Replace switch. Repair wiring
Damaged or disconnected temp
probe
Check probe. Reconnect or
repair
Damaged oven relay Replace relay
Damaged air heating element(s) Replace one or both elements
Damaged oven controller Replace controller
Fan does not run
Fan switch in OFF position Press fan switch to HIGH or LOW
Fan wheel loose on shaft Tighten fan set screws
Motor start capacitor or wiring
damaged
Replace capacitor. Repair wiring
Motor or wiring damaged Replace motor. Repair wiring
Door pops open during cook
cycle
Hinge out of adjustment Adjust hinge
Door strike loose tighten strike screws
Door latch damaged Replace latch
No power to appliance
SV506 SvcManual WVOC-4H
Comments to this Manuals