Wells HDHP-1230G User Manual download pdf (Page 9)

ENGLISH

INSTALLATION (continued)

226 306627 OpManual for HDHP-Series Hot Plates

SET GAS PRESSURE:

Gas pressure regulator is factory set.

SET PILOT FLAME:

The pilot adjustments are located between the control valves for

each set of burners. The right valve controls the front pilot; the

left valve controls the rear pilot.

Using a small, flat-blade screwdriver, turn the screw clockwise to

decrease the flame size, or counter-clockwise to increase the

flame size.

Adjust the pilot flame to 1/4” high. Test for operation: inside and

outside sections of the burner must light without undue delay.

Drafty conditions may require a higher flame to allow the pilot to

remain lit.

ADJUST BURNER FLAME:

Remove all burner control knobs, then remove the front panel.

Turn an individual burner on. The right knob controls the front

burner; the left knob controls the rear burner.

Loosen the locking screw on the shutter.

Turn the shutter to admit more or less air as required. Adjust the

air shutter until the flame is mostly blue in color.

Tighten the locking screw when finished. Replace the front panel

and all knobs before returning the unit to service.

Fig. 3 Adjustments

IMPORTANT:

Adjustments must be performed

by a qualified technician only.

IMPORTANT:

This hotplate is shipped from

the factory equipped for either:

natural gas and adjusted for

sea level to 2000 feet elevation;

or, propane (LP) gas and

adjusted for sea level to 5000

feet elevation.

For operation other than listed

above, contact your Authorized

Wells Service Agency.

1 2 3 4 5 6 7 8 9 10 ... 30

No comments

Wells HDHP-1230G User Manual Page 9