PREPARATION
IMPORTANT: Be sure filter unit and all components are dry. Water
contamination will result in splattering hot oil.
Prepare Filter (if needed due to used filter envelope):
Remove reservoir cover. Remove
filter assembly at filter union. Detach
filter clip. Discard used filter.
Slide fresh filter bag over filter cage.
Be sure hole in bag is in position over
adapter fitting.
Fold end of bag, secure with filter clip.
Attach filter adapter to filter cage.
Attach to pump at filter union.
Reinstall reservoir cover.
Position Filter Unit:
Roll filter unit under fryer so that front lip of reservoir is under fryer
drain valve. Be sure power switch is OFF, then connect filter unit to
electric power. Be sure all fryer pressure is dissipated. Open fryer
lid and slide lid to rear.
FILTER OIL
IMPORTANT: Oil must be at 150ºF or higher for proper filtration.
Connect POLISHING WAND to pump
with the discharge end in the center
hole of the reservoir cover.
See illustration at right.
Open fryer drain valve, drain all oil
into the reservoir. Close drain valve.
Press the power switch to ON.
Polish the oil for 5 - 7 minutes.
Press the power switch to OFF.
Disconnect polishing wand from pump
and stow in tool storage bracket.
Connect the TRANSFER WAND to the pump.
Lift discharge nozzle, then swing end of transfer wand over frypot.
Allow discharge nozzle to drop into position.
Press the power switch to ON. Allow the pump to run until as much
oil as possible has been returned to the frypot.
Press the power switch to OFF.
Disconnect transfer wand from pump and connect to wand drain
fitting.
When dripping from transfer wand has stopped, disconnect and
stow wand in tool storage bracket.
OPERATION
5
DANGER:
BURN
HAZARD
Contact with hot shortening
will cause severe injury or
death. Wear eye protection,
protective gloves and clothing
and when operating or
servicing this fryer.
DANGER:
BURN
HAZARD
Do not attempt to open the
fryer lid or fryer drain valve
until the pressure in the frypot
has fallen to zero.
Opening the lid or valve
prematurely will result in the
explosive release of hot
shortening.
Contact with hot shortening
will cause severe injury or
death.
CAUTION:
HOT SURFACE
Exposed surfaces can be hot
to the touch and may cause
burns.
IMPORTANT:
DO NOT push or pull the filter
unit by the wand or discharge
pipe. Always use the push
handle to maneuver the filter
unit into place.
IMPORTANT:
Empty reservoir after filtering
or polishing.
DO NOT allow shortening to
solidify in the reservoir.
When finished:
Wind power cord around
holding bracket.
Drain oil from transfer
wand
Store wands in tool
storage bracket.
USE AND CARE
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals